Opel Omega

since 1993-1999 of release

Repair and car operation

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
- 8. Coupling
   8.1. Technical characteristics
   8.2. Hydraulic system of a drive of switching off of coupling
   8.3. Main cylinder
   8.4. Working cylinder
   8.5. Coupling pedal
   8.6. Coupling disks
   8.7. Main malfunctions, their reasons and elimination methods
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

8.6. Coupling disks


1. Remove a transmission.
2. Mark the provision of installation of a press disk on a flywheel.
3. In a diagonal order gradually turn off fixing bolts and remove press and a frictional disk. Not to damage a diafragmenny spring, it is recommended to use the special tool (shooters specified an arrangement of fixing clips of a press disk).


1. Examine a frictional surface on existence of the wear, the loosened rivets or pollution. Examine press a disk on existence of deformation, the cracks, the broken plates of a diafragmenny spring and wear of shliyets. Replace a disk if it is necessary.
2. Examine surfaces of a flywheel and a press disk. If they are strongly scratched or on them there are flutes or cracks, replace them.
3. Check a condition of the vyzhimny bearing.


1. Wipe press a disk and a flywheel.
2. Establish a frictional disk on a flywheel springs outside.
3. Establish press a disk and acquire fixing bolts.
4. Establish a frictional disk precisely on the flywheel and casing center and gradually in a diagonal order tighten fixing bolts till the demanded moment of an inhaling.